An in-drawer knife organizer, made for your knives.

Narrow lanes keep blades apart so edges don't knock together and fingers stay clear. Size each slot for the knives you own.

Example layouts

3D render: Chef's set drawer insert, 7 compartments, PETG Matte Black

Chef's set

8″ × 18″ × 3″ drawer · 7 compartments · PETG Matte, Black · 2 locking pieces

Five narrow knife lanes in an 8″-wide drawer, one knife per lane, with bays for shears and a steel at the back.

Open this layout in the designer →
3D render: Knives plus tools drawer insert, 7 compartments, PLA Wood Black Walnut

Knives plus tools

12″ × 18″ × 3″ drawer · 7 compartments · PLA Wood, Black Walnut · 2 locking pieces

Four knife lanes, a bay for kitchen shears and two at the back. Wood PLA looks like a butcher block.

Open this layout in the designer →

Sizing knife slots

Measure the widest point of each handle. Most chef's knife handles are under 1¼″ wide, and a 1½–2″ lane leaves room to grab it. Lanes run front to back with the handles toward you.

Good to know

  • Choose flat pocket bottoms for knives so blades lie flat.
  • Keep the dividers full height so blades can't slide into the next lane.
  • Wood-fill PLA gives a butcher-block look. Keep it away from heat.

Questions

Will knives dull on plastic?

Lying in a lane, the edge doesn't rub on anything. The point of the organizer is to stop knives knocking into each other.

Can I fit a long bread knife?

One piece can be up to 13.1″ long. For longer knives, make the drawer deep and run the lanes front to back.

More ideas

Measure, design, done.

See your insert in 3D and get an exact price in a few minutes.

Start designing →