A vanity drawer organizer that shrugs off water.

Bathroom drawers get damp. Printed plastic doesn't swell, stain or grow mold the way wood and bamboo can. Rinse it and put it back.

Example layouts

3D render: His-and-hers vanity drawer insert, 6 compartments, PETG Glossy White

His-and-hers vanity

12″ × 16″ × 3 1/2″ drawer · 6 compartments · PETG Glossy, White · 2 locking pieces

Two matching columns, one per person. Over 12.4″ deep, so it's two locking pieces.

Open this layout in the designer →
3D render: Small vanity drawer drawer insert, 5 compartments, PLA Pure Milky Pink

Small vanity drawer

10″ × 12″ × 3″ drawer · 5 compartments · PLA Pure, Milky Pink

Three small bays in front, two bigger ones in back.

Open this layout in the designer →

Why plastic in the bathroom

Damp toothbrushes, wet razors and spilled products are hard on wood and bamboo. PETG and PLA don't absorb water, so the insert stays clean. Lift it out and rinse it in the sink.

Layout tips

  • Lower the dividers so tall bottles still fit.
  • Use scooped bottoms for hair ties and bobby pins.
  • Give each person a column so everyone knows what's theirs.

Questions

Can it get wet?

Yes. Rinse it with warm, soapy water. Avoid very hot water and the dishwasher's heated dry.

Can I fit a hair dryer?

If the drawer is deep enough. Inserts can be up to 4.7″ tall. Leave one large open bay.

More ideas

Measure, design, done.

See your insert in 3D and get an exact price in a few minutes.

Start designing →